Shark Citycruiser Manual Del Usuario página 11

VISOR REMOVAL
1 - Open the visor just slightly. Remove it
from its slot by means of a forward pulling
motion. Repeat this step on the other side.
VISOR INSTALLATION
1 - Position the visor by aligning the notch
with the silhouette.
2 - Refasten the prong onto the dial by
applying pressure toward the back. Repeat
this step on the other side.
VISOR SCREEN
WARNING! If you are not sure that you
properly replaced the visor, do not use the
helmet. The visor could suddenly and without
warning become detached from the helmet while
riding, causing you to lose control of your motor-
cycle, resulting in an accident, personal injury, or
death. Contact your retailer for any assistance or
advice.
WARNING! While riding at highway speeds,
do not ride with an open visor and do not
try to open the visor. The visor could become
dislodged, leaving your eyes and face unprotec-
ted. In addition, your head could be pulled to the
side. These events could cause you to lose control
of your motorcycle, resulting in an accident,
personal injury or death.
WARNING! Tinted or dark visors should
never be used at night or under poor visibi-
lity conditions as they reduce your ability to see.
Never ride with a fogged visor.
WARNING! If your visor no longer provides
you with clear visibility after a period of
service, you must immediately replace it. Never
ride with your vision obscured in any way. Always
ride with perfect visibility.
11