Specifications - Nikon SB-30 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Specifications

Electronic construction
Automatic Insulated Gate Bipolar Transistor (IGBT) and
series circuitry
Battery
One 3V lithium battery (CR123A or DL123A)
Guide number (ISO 100, m/ft.)
16/52 at 28mm angle of coverage (without wide-flash
adapter)
10/33 at 17mm angle of coverage (with wide-flash
adapter in place)
Angle of coverage
Covers the picture angle of 28mm lens (without wide-flash
adapter)
Covers the picture angle of 17mm lens (with wide-flash
adapter in place)
Power switch
Three positions provided: OFF/ON/STBY
ON/STBY position: Power is turned on.
STBY position: the SB-30 automatically turns itself off to
conserve battery when flash unit is not used for approx.
40 sec.
Recycling times and number of flashes
Minimum recycling time: Approx. 4 sec. (when fired at
M1/1 output using a fresh battery)
No. of flashes: Approx. 250 times (when fired at M1/1
output using a fresh battery)
34
Mode selector dial
Four positions provided: TTL auto flash, Non-TTL auto
flash (4 steps), Manual flash (3 steps), Wireless slave
flash (A or M)
Ready-light
Lights up when SB-30 is recycled and ready to fire.
Blinks when flash fires at its maximum output, indicating
light may have been insufficient (in TTL auto flash, Non-
TTL auto flash modes) The ready-light inside the camera's
viewfinder blinks when the camera settings are not
correct in TTL auto flash mode.
Standby resume button/Slave flash firing cancel button
Turns SB-30 on again after it enters standby state.
Prevents SB-30 from firing accidentally in slave flash
operation.
Flash duration
1/2800 sec. at M1/1 output
Dimensions (W x H x D)
Approx. 58.5 x 83.5 x 36 mm (2.3 x 3.3 x 1.4 in.)
Weight (without battery)
Approx. 92g (3.2 oz.)
All performance data and specifications are applicable when a
fresh battery is used at normal temperatures (20°C/68°F).
Specifications and design are subject to change without notice.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido