Installing The Battery; Battery Performance - Nikon SB-30 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing the battery

1
1 Set the SB-30's power switch to the OFF position.
2 Open the battery chamber lid as indicated by the arrows.
3 Install the battery following the + and – marks as shown. Then close the battery chamber lid by
sliding it into place while pressing down.
• Install one 3V lithium battery (CR123A or DL123A). Do not use the other types of batteries.
• When replacing the battery, be sure to set the power switch to the OFF position. If the battery is replaced
while the power switch is set to the ON or STBY (standby) position, the Speedlight may fire accidentally or
the power may not turn on correctly. In this case, set the SB-30's power switch to the OFF position once,
then set it back to the ON or STBY position. (p. 7)

Battery performance

• When using a fresh battery, the number of flashes when the SB-30 fires at M1/1 output is approx. 250 times.
• With a fresh battery, the recycling time after the SB-30 fires at M1/1 output is approx. 4 seconds.
• Replace the battery, if the ready-light takes more than 30 seconds to light up when the unit first turned
6
on or after firing the unit.
2
3

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido