Milwaukee 0513-21 Manual Del Operador página 7

To reduce the risk of personal injury
always unplug the charger and remove
the battery pack from the charger or tool
before performing any maintenance.
Never disassemble the tool, battery pack
or charger. Contact a MILWAUKEE ser-
vice facility for ALL repairs.
Keep your tool, battery pack and charger in good repair by adopting a
regular maintenance program. After six months to one year, depending
on use, return the tool, battery pack and charger to a MILWAUKEE
service facility for:
• Lubrication
• Brush inspection and replacement
• Mechanical inspection and cleaning (gears, spindles,
bearings,housing, etc.)
• Electrical inspection (battery pack, charger, motor)
• Testing to assure proper mechanical and electrical operation
Maintaining Tool
If the tool does not start or operate at full power with a fully charged
battery pack, clean the contacts on the battery pack. If the tool still does
not work properly, return the tool, charger and battery pack to a
MILWAUKEE service facility for repairs.
Maintaining Battery Pack
MILWAUKEE Nickel-Cadmium battery packs will operate for many years
and/or hundreds of cycles when they are maintained and used accord-
ing to these instructions.
A battery pack that is stored for six months without being used will
discharge itself. Batteries discharge at a rate of about 1% per day.
Charge the battery every six months even if it is unused to maximize
battery life. Do not tape the trigger in the "ON" position and leave the tool
unattended as this may discharge the battery to a point where it will no
longer be able to recharge. Use a MILWAUKEE battery pack only until it
no longer performs with the power and torque needed for your applica-
tion.
Store your battery pack in a cool, dry place. Do not store it where the
temperature may exceed 120°F (50°C) such as in a vehicle or metal
building during the summer. High temperatures will overheat the battery
pack, reducing battery life. If it is stored for several months, the battery
pack will gradually lose its charge. One to three cycles of charging and
discharging through normal use will restore the capacity of the battery
pack. During the life of the battery pack, the operating time between
charges becomes shorter. If the operating time becomes extremely short
after a proper charge, the usable life of the battery pack has been
reached and it should be replaced.
To reduce the risk of personal injury and
damage, never immerse your tool, bat-
tery pack or charger in liquid or allow a
liquid to flow inside them.
Cleaning
Clean dust and debris from charger and tool vents. Keep tool handles
clean, dry and free of oil or grease. Use only mild soap and a damp cloth
to clean the tool, battery pack and charger since certain cleaning agents
and solvents are harmful to plastics and other insulated parts. Some of
these include gasoline, turpentine, lacquer thinner, paint thinner, chlori-
nated cleaning solvents, ammonia and household detergents containing
ammonia. Never use flammable or combustible solvents around tools.
WARNING!
WARNING!
MAINTENANCE
To reduce the risk of explosion, never
burn a battery pack even if it is damaged,
dead or completely discharged.
Disposing of Nickel-Cadmium Battery Packs
Nickel-Cadmium battery packs are recyclable. Under various state and
local laws, it may be illegal to dispose of this battery into the municipal
waste stream. Dispose of your battery pack according to federal, state
and local regulations.
Repairs
For repairs, return the tool, battery pack and charger to the nearest
service center listed on the back cover of this operator's manual.
Battery Pack Warranty
Battery packs for cordless tools are warranted for one year from the
date of purchase.
Every MILWAUKEE tool is thoroughly inspected and tested before leav-
ing our manufacturing facilities. Should any trouble develop, return the
complete tool prepaid to our Corporate Office, Branch Office/Service
Center or nearest Authorized MILWAUKEE Service Station. If inspection
shows the trouble is caused by defective workmanship or material, all
repairs will be made without charge, and the tool will be returned, trans-
portation prepaid. Battery packs for cordless tools are warranted for
one year from the date of purchase.
This warranty does not apply where: (1) repairs or attempted repairs
have been made by persons other than MILWAUKEE personnel or Au-
thorized Service Station personnel; (2) repairs are required because of
normal wear; (3) the tool has been abused or involved in an accident; (4)
misuse is evident, such as caused by overloading the tool beyond its
rated capacity; (5) the tool has been used after partial failure or (6) the
tool has been used with an improper accessory. No other warranty,
written or verbal, is authorized.
WARNING!
WARRANTY
page 7