Virutex PL11 Manual De Instrucciones página 5

6. POSITIONING THE
DOVETAILING ATTACHMENT
To use the dovetailing attachment it is necessary
to secure it to a bench or worktable using the drill
holes A (Fig. 1) provided on both sides of the base.
The front
attachment must extend over the
end of the table in order to have
enough room free for the vertical
wood to pass.
7. POSITIONING THE WOOD
Place wood B (Fig. 2) between the teeth on the
attachment by moving stop G using knob D, to
centre the start of the first dovetail (Fig. 3).
So that wood pieces B and F are jointed when
assembled the lateral movement needed is
automatically obtained from the limiters G and
the adjuster D.
Secure wood B with knobs E without letting it
touch the attachment: it simply acts as a stop
for when wood F is put into place.
Position wood F so that it stops up against wood
B at the front and against stop G at the side and
secure it with the upper knobs H.
Release the front knobs E which secure wood B and
move it up against the attachment and against G
on the side. Secure it again using knobs E.
We recommend making two dovetailing trims
each time, one at each end of the attachment. If
only one end is used you should place some wood
of equal thickness to B and F at the other end so
that the clips are not forced when securing the
wood with knobs E and H respectively.
8. ADJUSTING THE TRIMMER
Fit the bit into the chuck on the trimmer and
place the surface routing head in such a position
that its base is 21.5 mm from the end of the
bit (Fig. 4) using the millimeter measure which
comes with the dovetailing attachment.
9. ADJUSTING THE MILLING DEPTH
Different degrees of fit in the joint can be
obtained by adjusting the distance between the
surface routing attachment and the bit following
of the dovetailing
the markings on the millimeter measure.
We recommend a distance of 21.5 mm between
the base of the surface routing attachment and
the point of the bit to obtain normal fitting joints.
If tighter fitting is required increase the
trimming depth above that shown on the
millimeter measure.
If looser fitting is required reduce the trimming
depth.
10. MAKING THE TRIMS
Place the trimmer on the surface of the
dovetailing attachment, follow the contours of
the teeth on the attachment moving the trimmer
smoothly and the male dovetailing joints will be
obtained and their corresponding positions.
11. WARRANTY
All VIRUTEX tools are guaranteed for 12 months
from the date of purchase, excluding any
damage which is a result of incorrect use or of
natural wear and tear on the. All repairs should
be carried out by the official VIRUTEX technical
assistance service.
VIRUTEX reserves the right to modify its products
without prior notice.
F R A N Ç A I S
GABARIT A QUEUE D'ARONDE PL11
1. INSTRUCTIONS DE SÉCURITÉ
POUR LE MANIEMENT DU GABARIT
Lire attentivement la BROCHURE
DES INSTRUCTIONS GÉNÉRALES DE
SÉCURITÉ, jointe à la documentation
de la machine.
1.1 Vérifier avant de brancher l'affleureuse, que
la tension d'alimentation correspond à celle
indiquée sur la plaque des caractéristiques, et
vérifier la position correcte de l'affleureuse sur
la surface du gabarit.
1.2 Ne pas retirer l'affleureuse de la surface du
gabarit tant que la fraise n'est pas arrêtée.
5