Spa Set-Up - mspa Mont Blanc Manual Del Usuario

SPA SET-UP

1. Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
2. Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
3. Spread the Heat Preservation Ground Mat over a cleared area. Spread out the spa liner over the ground
mat. Heat Preservation Mat prevents heat loss from the bottom of the unit.
1
● NOTE:
Soho P-SH06: Spread out
the square ground mat and
place it to the selected site.
Make sure the buckle of
cover and mat is attached
when spa not in use.
4. Connect the digital cable. Find
the digital cable, loose the cap on
the end, and plug into the cable
port on the control panel. Once
the cable is connected properly,
the backlight of the buttons area
will light up on the panel.
5. Connect the control panel to the spa tub. Fasten and
secure the rings to the pipe adapter on the spa tub.
(Fig.5) Make sure the rubber O-rings are properly
placed on the air pipes.
CAUTION: Lost of the O-rings may result spa and the
bubbling function working improperly, and also cause
the air pump rusted.
NOTE: For spa models have PVC leather covers, make
sure the spa cover is onto the spa tub properly before
connecting the control panel. The two holes on the leather cover must be positioned correctly to the pipes
of control panel air pipes.
2
4
12
3
this side
face down
5
Air pipe
O-rings