GE 20 Serie Manual Del Propieratio página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

About the controls with
temperaturesettings. (for
o ther models, see next page)
NOTE: Therefrigerator is shipped with protective film covering the temperaturecontrols.
If this film was not removedduring installation, remove it now
The temperature controls are preset in the factory at 37°t: for the refrigerator compartment
and O°F for the freezer compartment. Allow24 hours for the temperature to stabilize to the
preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly from
the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
Changing the Temperature
To change the temperature,
press and release the
WARMER
or COLDER pad.
The
Sk'Tlight
will corn e
on and
the
display
will show
the
set teml_eramre.
To change
the
temperature,
tap
either
the
WARMERor COLDER
pad
tmfil
the
desired
temperature
is displayed.
Refl_igerator
temperatures
can be ac!iusted
between
34°F and
47°F and
the
fl'eezer
teInperatures
can be ac!iusted
between
-6°F
and
+8°E
Once
the
desired
temperature
has been
set,
the
temperatm'e
display
will return
to the
actual
refl-igerator
and
fl'eezer
teinl)eratures
atter
5
seconds.
Several
ac!jusunents
ina)' be required.
Each time you ac!iust controls,
allow 24 horns fiw the
refrigerator
to reach
the temperature
you have set.
Toturn the cooling system off, tap the WARMER pad
for either
the refl-igerator
or the ti'eezer
until the
display shows OFF.To turn the unit back on, press the
COLDERpad flw either
the refl'igerator
or fl'eeze_:
The SETlight will illmninate
on the side y(m
selected.
Then
press the COLDERpad again
(on the
side where
the SETlight is illuminated)
and it will
go to the preset points
of O°Ffor the fl'eezer
and
37°Ffor the refiJgerato_:
Setting
either
or both
controls
to Off stops cooling
in both the ti'eezer
and refi-igerator
compartments,
but does not shut
off electrical
power
to the refl_igerator.
Performance Air Flow System
The
Perfimnance
_Mr How
System
is designed
to
maximize
temperatm'e
control
in the
refl-igerator
and
fl'eezer
compartments.
This
tmique
special
teatm'e
consists
of the
_dr Tower
along the back
wall of the
refl_igerator
and
the _dr Ttmnel
on the
bottom
portion
of the
fl'eezer
rear
wall. Placing
ti)o(1 in fl'ont
of the lou\'e_
on these
components
will not
affect
perlbmmnce.
4

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

22 serie

Tabla de contenido