Technical Specifications - AEG KHF 4217 Instrucciones De Servicio

Juego de auriculares radioeléctrico en estereo
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
English
38
NOTE:
After turning the headphones back on, CHANNEL 2 is
automatically set as the reception frequency.
Use with cable
To use the headphones with a cable, you must be close
to an audio source and take into account the length of
the cable.
1. Move the ON/OFF switch (9) to the OFF position to
save battery power.
2. Set the WL/OFF mode switch (4) to OFF.
3. Connect the external audio source to the 3.5 mm
stereo TRS connector AUDIO jack (5) on the head-
phones using the correct adapter cable.
4. Adjust the volume on the audio source.
NOTE:
• The volume control (3) on the headphones does not
function in this mode.
• The transmitter/charging station does not need to
be switched on in this mode.
Troubleshooting
Poor or fuzzy sound
• Have you changed the channel? Press the SCAN
channel selection button (2) in order to obtain the
best reception.
• Check the distance to the transmitter. Walls and ceil-
ings reduce the range.
• Are the batteries charged up?
• There may be interference from other radio emit-
ting equipment such as cordless telephones, mobile
telephones or CB radio.
No headphone reception
• Are all the components switched on?
• Is the ON/OFF switch (9) in the ON position?
• Is the mode switch WL/OFF (4) set to WL?
• Are all the electrical connections correct?
• Have the batteries been inserted?
• Is the sound source switched on and is a sound signal
being transmitted? The POWER LED (11) only lights
up when the transmitter is receiving an audio signal.
• Is there still no reception despite having checked all
the points above? Transmitter may be blocked, may
"hang". Disconnect the power supply from the mains
for about 5 sec. Then switch the device back on.
Mono sound
• Are you receiving only a mono signal? Turn the audio
source to stereo.
Interference
• Turn the switch (15) to another channel. Press the
SCAN channel selection button (2) repeatedly until
the sound of the audio source can be heard.
AUTO OFF function
• The transmitter has an AUTO-off function. If the
input signal is very quiet or switched off for approx.
1 min., the transmitter switches off automatically.
Turn up the sound of the audio source or check
whether an audio signal is still being transmitted.
Technical Speciications
Model: ................................................................................. KHF 4217
Net weight (Total): ..............................................................0.61 kg
Mains Adapter
Protection class: .............................................................................. II
Input: ..................................................................... AC 230 V, 50 Hz
Output: ................................................................... DC 5 V, 200 mA
Polarity: ...................................................................................
Transmitter
Power supply: .........................................................................DC 5 V
Alternative power supply: ........................... 3x 1.5 V AAA/R03
Power consumption:..............................................................2.0 W
Range without obstructions:......................................80 meters
Number of radio channels: ..........................................................3
Channel frequency: ......................................863.5 – 864.5 MHz
Net weight: ............................................................................0.19 kg
Headphones
Frequency transmission: .................................... 30 Hz – 15 kHz
Signal-to-noise ratio: ............................................................50 dB
Channel separation: ...............................................................40 dB
Power supply: .......................................2 x Ni-MH rechargeable
Net weight: ............................................................................0.21 kg
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
batteries 1.2 V Type AAA

Publicidad

Tabla de contenido
loading

Tabla de contenido