Customer Service / Support; De-Commissioning; Drawings And Replacement Parts; Idling And Disposal - ABNOX AXKP 1 Manual De Instrucciones

Audible empty notification with pump shut-
down L (Figure K)
Audible signal when the grease is used up and the
pump has stopped. Signal is stopped by interrupting
the compressed air supply.
Connection block with pressure gauge ball
valve AB (Figure M)
Displays the outlet pressure and provides a simple
bleeding method.

Customer Service / Support

ABNOX AG
Langackerstrasse 25
CH-6330 Cham
Switzerland
Tel. +41 (0) 41 780 44 55
Fax +41 (0) 41 780 44 50
E-Mail info@abnox.com
Internet www.abnox.com

De-Commissioning

Brief Interruptions:
In the event of short interruptions (overnight or just
over the weekend), shut down the product. The
system must be de-pressurised.
Long-Term Interruptions:
In the event of a longer-term interruption (more than
three days), the following points should be observed:
• The main switch must be shut down
• The system must be de-pressurised (check the
displays)
CAUTION
Risk of accident and danger to the
environment:
Grease / oil on the ground increase
the risk of accident.
The grease/oil must be properly
disposed of in compliance with
applicable national ordinances
(hazardous waste).

Drawings and Replacement Parts

Accessories, drawings, dimensioning sheets, data
sheets and replacement parts can be found at
www.abnox.com.

Idling and Disposal

When de-commissioning/idling the product, please
heed the following points:
• Switch off the main switch (if any)
• Unplug the main power plug from the main supply
(if any)
• The system must be depressurised.
• The medium must be removed and properly
disposed of.
ENVIRONMENTAL HAZARD
The various materials /liquids must
be properly and separately handled
and disposed of in compliance with
the applicable national ordinances.
Lubricants are considered
hazardous waste.
© Publisher's Copyright
This document may only be reproduced, translated
or made accessible to third parties with the expres-
sed consent of the publisher.

Re-Sale

This Operating Manual is a component of the product
and belongs in the scope of delivery in the event of
re-sale.
EN
27