Network Setting - Cameo AURO BAR 100 Manual De Usuario

Settings
Display Rev = Flip Display
Display = Display lighting
DMX Fail = Operation status with DMX
signal interruption
DimmerCurve = Dimmer Curve
Pan Rev = Pan Reverse
Tilt Rev = Tilt Reverse
Pan Angle = Pan Angle
Feedback = position correction
Mov Blackout = Automatic blackout during
head movement
Test = Function test
Reset = Reset
NETWORK SETTINGS (Network Setting)
Pressing the MODE button will take you to the selection menu for system settings. Using the arrow buttons, select the menu item "Network Setting"
(dark background) and confirm by pressing ENTER. You will then be taken to the sub-menu to set the following sub-menu items (select the sub-
menu items with +, -, set with ENTER, +, -, ENTER):
System Settings
DMX Address 001
Mode DMX 39CH
Settings

Network Setting

System Info
Network Setting
NetworkMode
IP Address = set the IP address
Subnet Mask = Adjust the subnet mask
Universe = selecting the
DMX universe
DMX Out = output of the DMX control
signal via DMX OUT sockets
ON = Rotation of the display by 180° (overhead installation)
OFF = no rotation of the display
ON = permanently on
OFF = deactivation after approx. 2 minutesa of inactivity
Hold = last command is held
Auto = activates the AUTO mode
Blackout = activates Blackout
Linear = The light intensity increases linearly with the DMX value.
Exp = Adjustment of the light intensity is finer in the lower DMX value range
and coarser in the upper DMX value range.
Log = Adjustment of the light intensity is coarser in the lower DMX value
range and finer in the upper DMX value range.
S-Curve = Adjustment of the light intensity is finer in the lower and upper DMX
value ranges and coarser in the middle DMX value range.
ON = Reversal of the Pan direction
OFF = no reversal of the Pan direction
ON = Reversal of the Tilt direction
OFF = no reversal of the Tilt direction
630 = Pan angle 630°
540 = Pan angle 540°
ON = activates automatic position correction
OFF = deactivates automatic position correction
ON = Blackout during head movement
OFF = no blackout during head movement
ON = step-by-step function test of LEDs and motors (Pan, Tilt,)
OFF = stops the function test
Pan&Tilt = Resetting of the Pan & Tilt motors
number 1 000-255
number 2 000-255
number 3 000-255
number 4 000-255
number 1 000-255
number 2 000-255
number 3 000-255
number 4 000-255
000-255
ON
OFF
Artnet
Select the numbers 1 - 4 by repeatedly pressing
ENTER
Change the value with + and -
Select the numbers 1 - 4 by repeatedly pressing
ENTER
Change the value with + and -
Change the value with + and -
= output of the DMX control signal via DMX OUT is
enabled
= output of the DMX control signal via DMX OUT is
disabled
19