pj PC-4324D Manual De Usuario página 33

Preparing Your Camera for Use
Install lithium battery
Your digital camera needs a lithium Li-ion battery in order to operate. To install it correctly see the
diagram below:
1. Slide and open the battery door on the bottom of the camera.
EN
2. Insert the battery correctly with the correct polarity facing up.
3. Close the battery door.
4. On powering on your camera the battery icon will appear on the bottom right of the LCD
screen.
Full battery power
Note:
1. In order to charge your lithium battery, make sure the battery is inserted correctly and then
connect your camera to PC with the USB cable provided. The red LED will light up indicating
that your camera is in charging mode. The LED will switch off when your camera is fully
charged.
2. A "Low battery" message will flash on the LCD when the battery power is insufficient. Shortly
thereafter your camera will power off.
3. Please remove your battery when you don't intend to use your camera for a long time.
4. Test photos taken with the camera should be downloaded otherwise they will be lost when
the camera loses power and turns off or when the battery door is opened to replace the
battery.
Installing SD Memory Card
An external memory card is required for normal use. Your camera supports
any compatible SD memory card (up to 32GB).
Adding a memory card will allow you to increase the capacity of camera
before you have to transfer test photos and videos to PC.
1. Locate the Memory Card slot at the base of the camera.
2. Insert the Memory card into the slot in the correct direction, see the
sketch below:
P-5
Medium battery power Low battery power