Water Connection; Electrical Connection - Kitchen Aid KRSC 9007 Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
For correct and safe installation of the appliance,
GB
please carefully read this manual and the other docu-
mentation provided (see section "Precautions and
general advice").
Specifications, technical data, images and parts
supplied may be subject to change without prior
notice.

WATER CONNECTION

Disconnect the appliance from the mains power
supply before starting operations.
• In any case, make sure to
comply with the current local
regulations regarding
connection to the water
system.
• The appliance is supplied with a
water tube, 1.8 m long, already
attached to the back of the
product.
• The water tube complies with
IEC 61770.
• Remove the shipping tape from the gray coiled
water tubing on the rear of the appliance.
• Connect the transition connector (1) to the
household water supply (2).
• Open the water tap and check for and eliminate any
leaks.
• The appliance does not require adjustments or a
water drain.

ELECTRICAL CONNECTION

Connect the appliance to the mains power supply.
Electrical safety of the appliance can only be
guaranteed if it is correctly connected to an efficient,
approved earthing system.
MOUNTING FREEZER DOOR
Important: If your appliance has two water fill pipes
(see figure), when mounting the door you must
reconnect the two pipes to the matching ones at the
bottom of the appliance, being careful to connect like
colours with like:
- white-white: water
- blue-blue: ice.
- Check for leaks after connecting the water fill pipes.
- Clear up any spills on the floor.
POSITIONING AND LEVELLING YOUR
REFRIGERATOR
If the appliance seems unsteady or you want the
doors to close more easily, adjust the appliance's tilt
following the instructions below (depending on the
model, as shown in the figures
on the right).
The refrigerator has two front
and two rear wheels at the
base of the product on each
side and two adjustable feet at
the front
(see figure A).
1. Check the installation location to be sure you have
at least 1 cm clearance on all sides including the
top.
2. Connect the appliance to the mains power supply.
3. Move the refrigerator into its final position.
4. Open both doors and remove the plinth to locate
the feet and levelling bolts
at the left and right of the
refrigerator base (where
present). The top bolt (1)
will adjust the rear wheel (if
provided), and the bottom
bolt (2) will adjust the front
wheel (see figure B).
5. Use the wrench provided (if present) to adjust the
levelling bolts. Turn clockwise to raise the appliance,
or anticlockwise to lower it. It may take several
turns of the levelling bolts and/or feet to adjust the
tilt of the refrigerator.
6. After levelling the product, ensure that both feet
touch the ground for safe use.
Note: do not unscrew the levelling bolts and feet
too much as they could fall out.
Aligning the doors
If, after switching on the appliance and adjusting the
refrigerator and freezer doors, the doors are
misaligned, disconnect the appliance from the power
supply and adjust both doors as indicated in the
diagram at the end of this manual.
Any damage resulting from FAILURE TO
FOLLOW THE INSTRUCTIONS during
installation will not be covered by the warranty.
REMOVING THE FREEZER DOOR (A)
REMOVING THE REFRIGERATOR DOOR (B)
MOUNTING THE FREEZER DOOR (C)
MOUNTING THE REFRIGERATOR DOOR (D)
HORIZONTAL ALIGNMENT OF FREEZER
AND REFRIGERATOR DOORS (E)
VERTICAL ALIGNMENT OF FREEZER
AND REFRIGERATOR DOORS (F)
INSTALLATION DIMENSIONS
AND REQUIREMENTS (G)
8
A
B

Publicidad

Tabla de contenido
loading

Tabla de contenido