Back Panel; Main Mix Output - LD Systems LD LAX8D Manual De Usuario

30
POWER
PHANTOM
ON OFF
AC INPUT
28 29
28 POWER ON/OFF SWITCH
This switch is used to turn the Main Power ON and OFF.
29
AC INPUT CONNECTOR
This connector is used to connect the supplied AC adapter.
30
PHANTOM ON/OFF SWITCH
This switch will apply +48 Volt Phantom Power only to the 6 XLR inputs sockets. When these XLR sockets are
connected with devices that do not require Phantom Power, please make sure the Phantom Power is turned
off, otherwise, this may damage the device and mixer.
31

MAIN MIX OUTPUT

The stereo output is supplied both XLR and 1/4" TRS sockets, which are used to send the audio signal to an
amplifier. Through the main mix level control, you can adjust the output level from - to +15dB.
32 CONTROL ROOM OUTPUT
These 1/4" phone sockets will be used to send the signal to studio monitor speakers or to a second set of
PA.
INSERT
33
Insert sockets are provided for each mono MIC channel. It can allow you patch external signal processing
devices into signal path via a TRS connector, the signal will be taken out after the input gain control (TRIM),
and sent to an external processor such as a compressor-limiter, then returned into the same channel
immediately before the EQ section.
Note: Usually, insert connections require a special stereo-splitting Y-cord to be connected, known as TRS
connector (Tip Send/Ring Return).
MAIN MIX OUTPUT(BAL/UNBAL)
RIGHT LEFT
31
MODEL
SERIAL
L L
4
INSERT
R R
OUTPUT CTRL ROOM
32

BACK PANEL:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
- DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE
- NE PAS OUVRIR
3 2 1
INSERT INSERT INSERT
33
13