Set-Up; Connection - Loewe SoundVision Instrucciones De Manejo

Loewe SoundVision
Instructions for Use

Set-up

Connection

Set-up
• Place the unit on an even, firm, horizontal surface.
• Do not set up the unit near strong heat sources or in direct sunlight.
• If setting up in a shelf or a closed cupboard: Leave at least 2.5 cm
clearance around the unit, so that the air can circulate unhindered
and there is no heat backup. Do not cover the openings at the back.
The device may not be laid on its back during operation.
• Incorrect voltages can damage the unit. This device may only be
connected to a power supply with the voltage and frequency indi-
cated on the type plate using the mains cable.
• Pull out the power cable during thunderstorms. A voltage surge
caused by lightning conducted through the mains could damage
the unit.
• If the unit is not to be used for an extended period, the plug should
also be disconnected from the mains.
• The power plug of the TV set must be easily accessible so that the
TV can be disconnected from the power supply at all times.
• Position the mains cable in such a way that it can not be damaged.
The power cable may not be kinked or laid over sharp edges, stood
on or exposed to chemicals; the latter also applies to the unit as a
whole. A power cable with damaged insulation can cause electric
shocks and poses a fire risk.
• When you want to unplug from the mains, pull on the plug housing
rather than on the cable. The cables in the mains plug could other-
wise be damaged and could cause a short-circuit when plugged
in again.
• Do not touch the unit on the display
handling, as it could be damaged by this. Do not touch the speaker
at the bottom of the unit.
Network
- 28 - - 28 -
when unpacking and
8
LAN ANT-FM AUDIO
OUT
USB USB
FM antenna
Connection
Remove the cable cover on the rear of the unit.
Use an RJ-45 network cable to connect the network socket LAN
to a network connection (e.g. switch or DSL router) of your home
network with a connection to the Internet.
Connect the socket ANT FM
13
an FM antenna socket.
You can connect an external audio source to the socket AUDIO IN
14 . Use an audio cable with 3.5 mm jack cable available from your
dealer.
Plug the network cable into the network socket AC-IN
nect it to a 220-240V 50/60 Hz socket.
You can connect a headphone with a 3.5 mm jack to the headphone
socket . The speakers of the unit are then switched off.
10
Replace the cable cover on the rear of the unit.
Example of cabling:
➠
The unit type plate is located under the cable cover or on the
bottom of the unit.
POWER
LINK AUDIO
IN
AC-IN
Mains cable
via an optional FM antenna cable to
16 and con-
9