Navigation In The Menu; Main Menu; Options Menu; Setting The Language - Loewe SoundVision Instrucciones De Manejo

Loewe SoundVision
Instructions for Use
Start-up

Navigation in the menu

These instructions for use describe the control of the unit via the touch
screen. The symbols in the left column of these instructions for use refer
to the symbols on the touch screen display. Functions are selected and
set by wiping gestures with the finger over the touch screen display.
The control functions (without settings) can also be made by remote
control (page 24).

Main Menu

You can call up the various functions of the unit via the main Menu.
You can make all entries directly on the touch screen by tapping on the
symbols with your finger.
Call up the Main Menu.
Back in menu.

Options menu

Customise SoundVision to your needs. The Options menu is context
sensitive, i.e. it displays different functions depending on the situation
from which it was called up.
Call up Options menu.

Setting the language

Set the desired menu language.
Call up Options from the Main Menu.
Call up Settings menu.
Select International option (second line from above)
Select desired Language.
Confirm selection with Set.
Confirm prompt with Restart.
- 30 -

Network

Depending on whether the device is connected by wire (Ethernet,
Powerline)
or wireless (WiFi), different settings have to be made.
➠
Loewe recommends use of a wired network (Ethernet, Powerline)
to ensure a high stability and quality of the data link. As a matter
of principle, wireless connections can get disturbed due to external
influences (e.g. microwave devices) and mostly provide a lower
data transmission rate.

Network Settings

You can make the settings for the selected network here.
Call up Options menu.
Call up the Settings menu.
Select the Network option.
You can see the current network settings. After the
first commissioning at the factory, your unit is set for a
wired connection and automatic IP configuration. If an
IP address is displayed in the network settings, a cor-
rect Internet connection is usually present and nothing
further has to be set.
If the unit does not have an Internet connection, change
the network settings.

Wired network

Call up Change Settings.
Select desired Connection - wired for the network
connection.
Confirm selection with Proceed.
Select desired IP configuration.
automatic If a DHCP server is present in your home network
(e.g. a DSL router), use this setting, as all network
parameters are set automatically.
manual The network parameters can be set manually (e.g. if
there is no DHCP server in your home network).
Confirm selection with Proceed.
The network parameters determined are displayed in
the overview in the automatic option.
Enter network parameters in the displayed data fields
with the manual optioon.
Proceed Confirm selection with Proceed.