Whale BP2082B Manual De Instalación Y Funcionamiento página 9

Isolator
Switch
Fuse
Battery
Fig 6b Wiring Gulper® IC to traditional switch - non Whale® IC accessories
11.vi CONNECT SWITCHING CABLE
If switching cable must be fitted through bulkhead, ensure a minimum hole diameter 25mm (1") is
drilled.
11.vii CONNECTING GULPER® IC TO WHALE® IC ACCESSORIES- GREY AND BILGE
APPLICATIONS (SEE FIG 1-2)
Connect the pre-wired Deutsch® connectors on Gulper® IC and Whale® IC accessory (see Fig 8.a)
11.viii. INSTALLATION FOR GULPER® IC WITH TRADITIONAL SWITCHES OR NON- WHALE®
IC ACCESSORIES (SEE FIG 2)
Fig 8a. STEP 1- Connect Deutsch® Connectors Fig 8b. STEP 2 - connect adaptor with 2 spades
Use Adaptor AK2081 (available separately) Deutsch® to traditional 2 spade connector lead to
connect to non Whale® IC remote mounted manual switch/ flow switch or gulley switch. (see Fig 2)
Step 1 - Connect Deutsch® connector on Gulper® IC to adaptor (see Fig 8.a)
Step 2 - Connect adaptor traditional 2 spade connections to traditional switch or non Whale®
IC accessory. (see Fig 8.b)
Override
Switch
On
Off
On
Off
Running
Red
Gulper IC
White
Black
Light
Fig 7- Connecting switching cable through
Deutsch
Connectors
bulkhead
Traditional
Switch
9