Publicidad
OPen
4
MX-V
ClOse
ClOse
OPen
English
tO aDJust PeaK anGle
Slightly loosen all three screws of the peak by hand or with a coin or flat blade
screwdriver if necessary so that the peak can be moved up and down without
scratching helmet surface. Put the helmet on and adjust the peak to the desired
position. Tighten the center screw finger tight and take helmet off. Align and
tighten all screws firmly but do not over-tighten.
WaRnInG:
Never attempt to adjust peak angle when in motion riding your motorcycle.
tO OPeRate Vents
Pull the slider down to open and push it up to close the duct as illustrated.
WaRnInG:
Never attempt to adjust ventilation ducts when in motion riding your
motorcycle.
nOte: Inner vent control gate allows the center air flow of the chin vent to be closed
more completely when riding in wet or cold conditions. Should more airflow be
desired when conditions are hot or humid, this gate can be removed by pulling on
the tab as shown. To replace, place bottom side of the inner vent control gate toward
the bottom of chin-bar opening, then push it fully into place as shown.
Publicidad
Capítulos
