Dometic WAECO PerfectView Serie Instrucciones De Montaje página 25

PerfectView M5L, M7L, M7LX
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
!
CAUTION!
 Secure the monitor in such a way that it cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause injuries to the occu-
pants of the vehicle.
 Do not attach the monitor in the area that may be used by an airbag, as this
could cause injury if the airbags are triggered.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp

(fig. <Waeco<Waeco>1 1, page 2) or a voltmeter (fig. <Waeco<Waeco>1 2,
page 2).
Test lamps with an illuminant (fig. <Waeco<Waeco>1 3, page 2) take up voltages
which are too high and which can damage the vehicle's electronic system.
 When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection
(fig. <Waeco<Waeco>3, page 3).
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulating tape, for
example to existing cables.
Observe the following instructions when handling the LCD monitor:
!
CAUTION!
 People (including children) whose physical, sensory or mental capacities or
whose lack of experience or knowledge prevent them from using this prod-
uct safely should not use it without the supervision or instruction of a respon-
sible person.
 Do not open the monitor (fig. <Waeco<Waeco>4, page 3).
 Do not submerge the monitor in water (fig. <Waeco<Waeco>5, page 3); the
monitor is not waterproof.
 The monitor may not impair your vision when driving
(fig. <Waeco<Waeco>8, page 4).
 Do not operate the monitor with wet hands.
 Do not operate the monitor if the housing has been damaged.
EN
Safety and installation instructions
25