Dometic WAECO PerfectView Serie Instrucciones De Montaje página 30

Mounting the LCD monitor
Choosing the installation location
➤
Place the monitor and the mounting rail on the monitor bracket
(fig. <Waeco<Waeco>a A, page 6).
➤
Place the monitor bracket and the mounting rail onto the support base and secure it
using the knurled nuts (fig. <Waeco<Waeco>a B, page 6).
➤
Position the monitor and the attached monitor bracket provisionally.
➤
Mark the outlines of the corners of the support base on the dashboard.
➤
Unscrew the support base from the monitor holder.
I
NOTE
You can fasten the support base using adhesive or screws.
Sticking the monitor bracket onto the dashboard (fig. <Waeco<Waeco>b A,
page 6)
➤
Remove the film from under the support base.
➤
Stick the support base to the position of your choice.
Screwing the monitor bracket onto the dashboard (fig. <Waeco<Waeco>b B,
page 6)
➤
Hold the support base within the outlines marked beforehand.
➤
Mark four different drilling points.
➤ Drill a hole of ∅ 2 mm at each of the points marked beforehand.
➤
Screw the support base on using 4 x 20 mm self-tapping screws.
Fastening the monitor
➤
Place the monitor and the mounting rail onto the support base and secure it using the
knurled nuts (fig. <Waeco<Waeco>a, page 6).
30
PerfectView M5L, M7L, M7LX
EN