Connecting The Monitor Electrically - Dometic WAECO PerfectView Serie Instrucciones De Montaje

PerfectView M5L, M7L, M7LX
7.3

Connecting the monitor electrically

The circuit diagram for the LCD monitor can be found in fig. <Waeco<Waeco>d, page 7.
No. in
fig. <Waeco<W
aeco>d, page 7
1
2
3
4
5
6
7
8
9
10
11
12
13
A
NOTICE!
Cables and connections that are not properly installed will cause malfunctions
or damage to components. Correct installation of cables and connections en-
sures lasting and trouble-free operation of the retrofitted components.
EN
Designation
Monitor
20-pin socket
Monitor line
20-pin plug
12–24 V positive cable (red): connected to the positive pole of the
ignition (connected positive, terminal 15) or the positive pole of the
battery (terminal 30).
Earth cable (black): connected to the negative pole of the voltage
source.
Cable (green): control input for video input C1,
e. g. for connection to the reversing light.
Cable (white): control input for video input C2,
e. g. side camera.
6 pin socket C1 (connection to video source 1)
6 pin socket C2 (connection to video source 2)
6 pin socket C3 (connection to video source 3)
M5L, M7L only: with video signal recognition)
M7LX only: 6 pin socket C4 (connection to video source 4,
with video signal recognition).
M7LX only: Cable (blue): Control input for video input C3.
Mounting the LCD monitor
31