Assembly And Operation; Charging Method - Metabo RP 3608DA Manual De Instrucciones

ASSEMBLY AND OPERATION

APPLICATIONS
○ General cleaning in workplaces and others.
○ Collection of fi ne dusts generated during
grinding, cutting or drilling of concrete or wood
using power tools.
○ Suction of liquid such as water spilt on the fl oor.
UNPACKING
○ Carefully unpack the power tool.
○ Take out the accessories in the tank before
work.

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure
the following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
1. Connect the charger's power cord to a
receptacle. When the power cord is connected,
the charge indicator lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger
as shown in Fig. 5.
Charge indicator lamp
3. Charging
When inserting a battery in the charger, the
charge indicator lamp will blink in blue.
When the battery becomes fully recharged, the
charge indicator lamp will light up in green.(See
Table 2)
(1) Charge indicator lamp indication
The indications of the charge indicator lamp
will be as shown in Table 2, according to the
condition of the battery charger or the battery.
English
Battery
Guide rail
Fig. 5
11