Metabo RP 3608DA Manual De Instrucciones página 13

Regarding electric discharge in case of new
batteries, etc.
As the internal chemical substance of new
batteries and batteries that have not been
used for an extended period is not activated,
the electric discharge might be low when
using them the fi rst and second time. This is
a temporary phenomenon, and normal time
required for recharging will be restored by
recharging the batteries 2 – 3 times.
How to make the batteries perform longer
(1) Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use
the tool and exhaust the electric current,
the battery may be damaged and its life will
become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery
life will be shortened. Leave the battery and
recharge it after it has cooled for a while.
CAUTION
● When the battery charger has been
continuosly used, the battery charger will
be heated, thus constituting the cause of
the failures. Once the charging has been
completed, give 15 minutes rest until the
next charging.
● If the battery is charged while it is heated
because it has been left for a long time
in a location subject to direct sunlight or
because the battery has just been used,
the charge indicator lamp of the charger
lights for 0.3 seconds, does not light for
0.3 seconds (off for 0.3 seconds). In such
a case, fi rst let the battery cool, then start
charging.
● When the charge indicator lamp fl ickers (at
0.2–second intervals), check for and take
out any foreign objects in the charger's
battery installation hole. If there are no
foreign objects, it is probable that the
battery or charger is malfunctioning. Take
it to your authorized Service Center.
HOW TO RECHARGE USB DEVICE
When an unexpected problem occurs, the data in
a USB device connected to this product may be
corrupted or lost.
Always make sure to back up any data contained in
the USB device prior to use with this product.
Please be aware that our company accepts
absolutely no responsibility for any data stored in
a USB device that is corrupted or lost, nor for any
damage that may occur to a connected device.
WARNING
● Prior to use, check the connecting USB
cable for any defect or damage.
Using a defective or damaged USB cable
can cause smoke emission or ignition.
● When the product is not being used, cover
the USB port with the rubber cover.
Buildup of dust etc. in the USB port can
cause smoke emission or ignition.
NOTE
○ The time required for charging will be longer
when a USB device and battery are being
simultaneously charged.
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, turn
the USB power switch OFF and remove the
USB device from the charger.
Failure to do so may not only reduce the battery
life of a USB device, but may also result in
unexpected accidents.
(1) Select a charging method
Depending on the charge method selected,
either the battery is inserted into the charger or
the power cord is plugged into an outlet.
○ Charging a USB device by battery (Fig. 6-a)
○ Charging a USB device from a electrical
outlet (Fig. 6-b)
○ Charging a USB device and battery from a
electrical outlet (Fig. 6-c)
a
English
b
Fig. 6
c
13