Troubleshooting Guide - Metabo RP 3608DA Manual De Instrucciones

TROUBLESHOOTING GUIDE

● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the
power source or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians.
Contact metabo HPT Authorized Service Center.
1. Cleaner
Symptom
Tool doesn't run
Suction power is weak.
Fails to suck in dust.
Dust leaks from the
vent.
Tool suddenly stopped Tool was overburdened
Attachments such as
the connection adapter
or joint
-can't be attached
-fall off
Battery cannot be
installed
WARNING
Possible cause
No remaining battery power
Battery isn't fully installed.
Concrete dust is accumulated on the
terminals of the battery installation
compartment as well as on the battery
sliding grooves.
The tank is full of dust or water.
Filter is clogged.
The fi lter is not installed.
(Not set in place)
Plastic bag is incorrectly installed.
Filter is not installed.
Filter is improperly installed.
Filter is damaged.
The battery and/or the unit is
overheated.
The shape or the dimensions of an
attachment part does not match.
Attempting to install a battery other
than that specifi ed for the tool.
Remedy
Charge the battery.
Push in the battery until a click is
heard.
Clean off the accumulated concrete
dust with a dry cloth.
Dispose of the dust or water.
After that, remove any dust attached to
the fi lter.
Conduct air blow dusting or remove the
dust attached to the fi lter.
Check to see if the fi lter is properly set.
Properly install the plastic bag.
Properly install the fi lter.
Replace the damaged fi lter.
Get rid of the problem causing the
overburden.
Let the battery and/or the unit cool
down.
Check the model in use and make sure
to use the designated accessories and
attachments listed in this document or
in our catalogue.
Please install a multi volt type battery.
English
23