Speedlink Dragonfly Instrucciones De Manejo página 4

Speed Link
D D
Dragonfly Joystick
GB
F
E
I
1. Fire button 1
2. Fire button 2
3. Fire button 3
4. Fire button 4
5. Automatic fire on/off
6. Trimmer X-axis
7. Trimmer Y-axis
8. Ergonomic handle
6
Introduction
Thank you for purchasing the Dragonfly Joystick.
Thanks to his ergonomic design the joystick is perfectly suited for
left-handers and right-handers. Numerous functions offer maximum
control and permit you to manage every situation of a game easily.
Configuration in Windows 95/98/ME/2000/XP:
1.Shut down your computer and switch it off.
2.Connect the 15-pin gameport plug of the joystick with the
gameport of your audio card or game card.
3.Restart your computer.
4.Open the start menu. Choose „Settings" and click on „Control
Panel". (Information: In Windows XP you can directly click on
„Control Panel").
5.Click on the symbol „Game Controller". Click on „Add" and
choose „2-axis, 4-button joystick".
6.Confirm by clicking on "OK".
7.A list of controllers appears on your screen, where your
driver should be listed. Please delete all other drivers from the
list.
8.Click "Properties" and than "Calibrate".
9.Follow the instructions in the calibration menu. After having
finished calibration please click on "Test page" to check the
functions of the joystick.
10.If all settings function correctly, click "Apply" and than "OK" to
complete the calibration procedure. If some settings don't
function properly, please repeat the calibration until all settings
are exactly performed.
Information: If the crosshairs aren't centred after the calibration,
you can also calibrate the X/Y-axis of your joystick manually by using
the trimmer (see figure: control 6 and 7) . For further information
please refer to chapter "Troubleshooting".
Please note that auto fire should be turned off during calibration.
7
D
D
GB
F
E
I