Lift Setting For Rkpowerlift Spindle - RK Rose+Krieger Powerlift Serie Instrucciones De Montaje

7. Working life

7.10.2 Lift setting for RKPowerlift spindle

It is essential to observe the dimensions given in the following drawing.
You must not have less than 48 mm! You must not have more than 559 mm!
Both will cause serious mechanical damage to the RKPowerlift and will entail the
voiding of any warranty claims!
With the RKPowerlift, you can change the installation
height or lift by adjusting the limit switch cams.
Follow these steps to do this:
•
For adjusting the installation height, drive out the RK-
Powerlift by about 5 mm more than the new in-
stallation height to be set. Position the RKPowerlift
to the lower end position (installation height) in order
to adjust the travel.
•
Place the RKPowerlift so that the lower opening
is easily accessible.
•
Loosen the fixed cam with an Allen key and pull it ca-
refully out of the groove together with the threaded
rod without using force.
•
Loosen the setting cam and adjust the lift and or in-
stallation height.
The default setting in the works is the smallest instal-
lation height and the maximum lift.
Please obey the warning notice to the letter!
•
Feed the setting cam carefully back into the groove
and push in without using force, until the fixed cam
engages firmly with the section.
•
Return the RKPowerlift to an upright position
and drive up carefully to the new end positions.
48
Setting cam
Lifting height
Setting cam
Installation
height
Fixed cam