Accessories And Parts; Mounting Instructions - Shure LEGENDARY PERFORMANCE SM7B Manual De Instrucciones

ACCESSORIES AND PARTS

Furnished Accessories
Switch Cover
Windscreen - Large
Optional Accessories
TRIPLE-FLEX™ Cable and Plug 7.6 m (25 ft.)
Replacement Parts
Cartridge
Windscreen - Small
Nut/Washer
+20
+10
0
–10
–20
2
20 50 100
Flat Response
4
3 4 5 6 7 9 8 2 3 4 5 6 7 9 8
1000 10000 20000
Hz
Presence Boost
Bass Rolloff

MOUNTING INSTRUCTIONS

The SM7B can be mounted on a microphone stand or hung from a boom. It is shipped
in the boom mounting configuration. To set up the SM7B in the microphone stand
mounting configuration, proceed as follows:
RPM602
1. Remove tightening nuts on the sides.
A7WS
2. Remove the fitted washers, the lock washers, the outer brass washers, and the
brass sleeves.
3. Slide the bracket off the microphone. Be careful not to lose the washers still on the
microphone.
C25F
4. Invert and rotate the bracket. Slide it back onto the bolts over the brass and plastic
washers still on the microphone. The bracket should fit so the XLR connector faces
the rear of the microphone, and the Shure logo on the back of the microphone is
right-side up.
5. Replace the brass sleeves. Be sure they are seated properly within the inner
washers.
6. Replace the outer brass washers, the lock washers and the fitted washers.
7. Replace the tightening nuts and tighten the microphone at the desired angle.
RPM106
NOTE: If the tightening nuts do not hold the microphone in position, one or both of the
RK345
brass sleeves may not be properly seated within all the washers.
RPM604
MICROPHONE STAND MOUNTING CONFIGURATION
RIGHT SIDE VIEW
BOOM MOUNTING CONFIGURATION
XLR CONNECTOR
RIGHT SIDE VIEW
SWITCH COVER
REAR VIEW
REAR VIEW