Makita 6796D Manual De Instrucciones página 4

ENGLISH
1 Battery cartridge
2 Set plate
3 Bit
4 Sleeve
5 Graduations
6 Adjusting grip
7 Switch trigger
8 Light
SPECIFICATIONS
Model
–1
No load speed (min ) ................................................ 320
Fastening torque ....................................................... 1 – 5 N . m
Overall length ............................................................. 174 mm
Net weight ................................................................... 1.4 kg
Rated voltage ............................................................. D.C. 9.6 V
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER & BATTERY CARTRIDGE
1. SAVE THESE INSTRUCTIONS — This manual
contains important safety and operating
instructions for battery charger.
2. Before using battery charger, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using
battery.
3. CAUTION — To reduce risk of injury, charge
only MAKITA type rechargeable batteries.
Other types of batteries may burst causing
personal injury and damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment not recommended or
sold by the battery charger manufacturer may
result in a risk of fire, electric shock, or injury
to persons.
6. To reduce risk of damage to electric plug and
cord, pull by plug rather than cord when dis-
connecting charger.
7. Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise sub-
jected to damage or stress.
8. Do not operate charger with damaged cord or
plug — replace them immediately.
9. Do not operate charger if it has received a
sharp blow, been dropped, or otherwise dam-
aged in any way; take it to a qualified service-
man.
4
Explanation of general view
9 Reversing switch lever
10 A side
11 B side
12 Clockwise
13 Counterclockwise
14 Warning lamp
15 Capacity limit of 6796D/FD
16 Range of fastening capacity
6796D/FD
10. Do not disassemble charger or battery car-
11. To reduce risk of electric shock, unplug
12. The battery charger is not intended for use by
13. Young children should be supervised to
ENC001-3
14. If operating time has become excessively
15. If electrolyte gets into your eyes, rinse them
ADDITIONAL SAFETY RULES FOR
CHARGER & BATTERY CARTRIDGE
1. Do not charge battery cartridge when tempera-
2. Do not attempt to use a step-up transformer,
3. Do not allow anything to cover or clog the
4. Always cover the battery terminals with the
5. Do not short the battery cartridge:
17 Revolution angle ( °)
18 Torque (Nzm)
19 Capacity limit of 6797D/FD
20 Capacity limit of 6798D/FD
21 Limit mark
22 Brush holder cap
23 Screwdriver
6797D/FD
320
2 – 8 N . m
174 mm
1.4 kg
D.C. 9.6 V
tridge; take it to a qualified serviceman when
service or repair is required. Incorrect reas-
sembly may result in a risk of electric shock or
fire.
charger from outlet before attempting any
maintenance or cleaning. Turning off controls
will not reduce this risk.
young children or infirm persons without
supervision.
ensure that they do not play with the battery
charger.
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
out with clear water and seek medical atten-
tion right away. It may result in loss of your
eyesight.
ture is BELOW 10°C (50°F) or ABOVE 40°C
(104°F).
an engine generator or DC power receptacle.
charger vents.
battery cover when the battery cartridge is not
used.
(1) Do not touch the terminals with any con-
ductive material.
(2) Avoid storing battery cartridge in a con-
tainer with other metal objects such as
nails, coins, etc.
(3) Do not expose battery cartridge to water or
rain.
6798D/FD
320
6 – 12 N . m
174 mm
1.4 kg
D.C. 9.6 V