Publicidad
Lectores/Readers/Lecteurs/Näherungsleser
Lectores/Readers/Lecteurs/Näherungsleser
EN
In this operating mode the reader is connected to a door controller. This provi-
des the system with anti-sabotage security by not incorporating the lock-release
or the output button on the reader itself. These functions are compatible with the
door controller. It can also be connected as a secondary reader to a MDS/VDS/
BUS2 display module.
The coding is done via the SW2 switch. On launching the reader in the fo-
llowing mode:
- Wiegand-26, the «+» led will light up for 1 second.
- Data/Clock, the «-» led will light up for 1 second.
In addition, an VDS type keypad can be connected to the CN3 connector to
provide more secure access controls which combine a 4 digit pin code and a card.
In this operating mode the cards are activated on the chosen central unit,
therefore capacity will depend on this.
Once activated, you can use them to open the relevant access door. To this
end, it is simply necessary to swipe (momentarily approximate) the card/keyfob
to the proximity reader.
As it operates on a radio frequency, no physical contact is necessary, meaning
you can even swipe the card without taking it out of your wallet. The maximum
reading distance is cm. With proximity keyfobs reading distance is 4cm.
The proximity reader has various light indicators, the meaning of which is the
following:
1
2
3
+
+
-
-
1. No Power.
2. Standby Mode. Door Closed.
3. Door Open.
Pag 21
Publicidad
