Blade Installation; Adjustments - AMBROGIO BASIC Manual De Uso

BLADE INSTALLATION

1-Before assembling and/or re-
placing the blade, make sure
that the robot has been stopped
in safety conditions (see "Robot
safety stop")
2-Turn the robot upside down
and put it down so not to ruin
the covering hood.
3-Assemble the blade (U).
Important
Respect the assembling direc-
tion of the blade.
4-Tighten screws (V).
5-Capsize the robot in its func-
tioning position.
Before turning the robot on,
check that the batteries are charged
(see "Battery recharge").
RECOMMENDATIONS FOR ADJUSTMENTS
Important
The user must carry out the adjust-
ments according to the procedures de-
scribed in the manual. Do not perform
any adjustments not explicitly indicat-
ed in the manual.
CHAIN TENSION ADJUSTMENT
1-Stop the robot in safety condi-
tions (see "Robot safety stop")
2-Undo the knobs (A).
3-Remove the hood (B).
blade (U)

ADJUSTMENTS

Any extraordinary adjustments, not ex-
plicitly indicated in the manual, must be
carried out only by the staff of the Au-
thorized Assistance Centres of the
Manufacturer.
knob (A)
- 21 -
screw (V)
blade (U)
hood (B)
GB
IDM - 41501602700.tif
IDM - 41501602100.tif
User's manual