Testing The Stapler - Hitachi N 3804AB2 Instrucciones Y Manual De Seguridad

English
CAUTION:
Do not free-fire the Stapler at high pressure.

TESTING THE STAPLER

Never use Stapler unless push lever is operating properly.
Before actually beginning the stapling work, test the Stapler by using the checklist below.
Conduct the tests in the following order.
If abnormal operation occurs, stop using the Stapler and contact a Hitachi authorized service
center immediately.
(1) DISCONNECT AIR HOSE FROM STAPLER.
REMOVE ALL STAPLES FROM STAPLER.
ALL SCREWS MUST BE TIGHTENED.
If any screws are loose, tighten them.
THE PUSH LEVER AND TRIGGER
MUST MOVE SMOOTHLY.
14
DANGER
Operators and others in work area MUST
wear safety glasses with side shields
which conforms
specifications.
WARNING
Push Lever
to ANSI Z87.1
Trigger
Do not connect
air hose