Vortice VORT-KRYO POLAR Manual De Instrucciones página 17

ENGLISH
Setting the timer
Press TIMER to set the required operating time (from 1
to 24 hours): the Timer light will come on and the display
will show how long the appliance is set to run for. After
this period, the appliance will switch itself off
automatically.
By pressing the button when the appliance is switched
off, the appliance can be set to start at a later time. (e.g.
pressing 2 means the appliance will start working 2
hours later)
Setting Night mode
If you press SLEEP while the appliance is in Cooling
Mode, the preset temperature will increase by 1°C after
one hour and by a further 1°C after the second hour.
In "Night" mode, fan speed is automatically set to its
lowest level. Pressing SLEEP again, the temperature
and fan speed return to their preset levels.
N.B.
The appliance switches itself off automatically after
operating for 12 hours of continuous running in Night
mode.
N.B.
Night mode can only be activated if the appliance is in
Cooling mode i.e. it is not an option in Fan or Dry
operating mode.
Auto-diagnosis
The appliance can carry out auto-diagnosis.
event of a malfunction, the display on the control panel
will show "E1" or "E2". In such event, contact an
authorised Vortice Service Centre.
N.B.
All the functions mentioned above can be activated from
the remote control unit provided (fig.17).
17 17
SLEEP
Use 3 Volt (CR2025) lithium batteries in the remote
control unit.
MODE
SPEED
TEMP
TIMER
"Super Cool" mode
To ensure that the appliance works properly in
"Super Cool" mode, make sure that the tank is filled.
The procedure is as follows:
• open the hatch (fig.18);
18 18
• remove the tank, open the lid with the handle (fig.19)
and fill it with water;
19 19
In the
• replace the tank.
The filter can be removed and cleaned (fig. 20).
20 20
17