Troubleshooting Guide - Parkside PGI 1200 A1 Instrucciones De Servicio Y Seguridad

13.Troubleshooting guide

Fault
Engine does not start
Generator has too little or no
voltage
Cause
Automatic oil cut-out has not responded
Spark plug fouled
No fuel
electronic defective
Overcurrent circuit-breaker has triggered Actuate the circuitbreaker and reduce
Air filter dirty
Remedy
Check oil level, top up engine oil
Clean or replace spark plug (electrode
spacing 0.6 mm)
Refuel / habe the petrol cock checked
Contact your dealer
the consumers
Clean or replace the filter
GB 43