Installing / Removing Battery Pack - Black+Decker LLP120 Manual De Instrucciones

InSTALLInG / REmoVInG BATTERy PACK

WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
To InSTALL BATTERy PACK: Insert battery
pack into tool until an audible click is heard
(figure C).
To REmoVE BATTERy PACK: Depress the
battery release button in the back of the battery
pack and pull battery pack out of tool.
PREPARInG ALLIGAToR LoPPER FoR USE
WARNING:
Read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury
WARNING:
Sharp moving blade. To prevent accidental
operation, ensure that the battery is disconnected from the tool
before performing the following operations. Failure to do this
could result in serious personal injury.
CAUTION:
Sharp moving blade. Always wear protective
gloves when installing or removing the chain. The chain is sharp
and can cut you when it is not running.
Chain tension adjustment
WARNING:
Before chain or other adjustments, make sure
that the battery is disconnected from the tool.
If the chain cannot be correctly tensioned, it may need to be
replaced. Contact your nearest service center.
The product comes ready assembled. However we recommend that
you check the tension of the chain, and chain retention bolts before
use and if required adjust.
Checking and adjusting the chain tension (figs. D, E)
C
To tension the chain slacken the
two chain cover retention bolts
(11) with the wrench (12) and the
atuomatic chain tensioning device
(fig E) will push the chain bar
out, setting the correct tension.
Retighten the two retention bolts
(11) securely.
Check that the correct tension has
been set by lightly pulling on the
chain. The tension is correct when
the chain snaps back after being
pulled 1/8 inch (3 mm) away from
the guide bar. There should be no
"sag" between the guide bar and
chain on the underside.
note: Do not over tension the chain
as this will lead to excessive wear
and reduce the life of the bar and
chain. It will also lead to reduced
product performance.
note: With first use and when the chain is new, check tension
frequently as a new chain stretches slightly.
Replacing the chain and chain bar
After prolonged use the chain and / or chain bar may need
replacing. Use Black+Decker replacement chain RC600 only.
Low-Kickback saw chain is a chain which has met the kickback
performance requirements of ANSI B175.1 when tested on the
representative sample of chain saws.
10
D
12
13 11
E