Maintenance; General Maintenance - Poulan Pro PPB4014 Manual De Instrucciones

GENERAL MAINTENANCE

• Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust,
oil, and grease, etc.
•
gasoline, petroleum-based products,
penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage,
weaken, or destroy plastic, which may
result in serious personal injury.
LUBRICATION
• All of the bearings in this product are
grade lubricant for the life of the unit under
normal operating conditions. Therefore, no
further lubrication is required.
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts may
create a hazard or cause product damage.
Always wear safety goggles or safety glasses
with side shields during power tool operation
or when blowing dust. If operation is dusty,
also wear a dust mask.
WARNING:
• To avoid serious personal injury, read and
understand all the safety instructions in
this section.
• Before performing any maintenance, make
sure the battery is removed. Failure to
heed this warning could result in serious
personal injury. To avoid serious personal
injury, read and understand all the safety
instructions in this section.
DANGER:
Never start the motor before
installing the guide bar, chain, chain cover,
and chain cover lock knob. Without all these
exposing the user to possible serious injury.
Never touch or adjust the chain while the
motor is running. The saw chain is very
sharp; always wear protective gloves when
performing maintenance to the chain to avoid
possible serious lacerations.
CAUTION:
Always wear gloves when
handling the bar and chain; these components
are sharp and may contain burrs.

MAINTENANCE

16