Poulan Pro PPB4014 Manual De Instrucciones página 18

• Lay out the new chain in a loop and
straighten any kinks. The cutters should
face in the direction of chain rotation. If
they face backwards, turn the loop over.
• Place the chain drive links into the bar
groove.
Cutters Chain Rotation
Cutters
Drive Links
NOTE: Make sure the direction of the chain is
correct .
• Position the chain so there is a loop at the
back of the bar.
• Hold the chain in position on the bar and
place the loop around the sprocket.
• Make sure the bar hole fits well with bolt
for saw chain tension.
• Replace the chain cover.
Chain Drive Links
MAINTENANCE
• Turn the chain tensioner screw with the
scrench clockwise until the saw chain is
properly tensioned. The guide bar must
then be pushed upwards, check chain
tension again, do not tension the chain too
tight.
• After the chain is well-tensioned, tighten
the bar nuts again.
Bar
Groove
18