®
The Freezer button serves two purposes:
To set the Freezer to your desired
temperature.
To turn the Power Freeze function on
and off.
) To set the Freezer temperature,
touch the Freezer button. You can set the
temperature
between 5 °F (-15 °C) and -8
°F (-23 °C).
1) Power Freeze function
Touch and hold this button for 3 seconds
to decrease the time needed to freeze
products in the Freezer.
It carl be helpful if you need to quickly
freeze easily spoiled items or if the
temperature
in the Ireezer has warmed
dramatically ([::or example, if the door was
lelt open).
When you use this function, the energy
consumption
of the refrigeralor will
increase. Remember to turn it off when
you don't need it and return the freezer
to your original temperature setting. If you
need to freeze a large amount of food,
activate the Power Freeze Iunction at least
24 hours before you put the feed into the
freezer.
renoh Door
The Alarm button serves two purposes:
To turn the door open alarm on and off
To reset the water filter life indicator.
Door Alarm Function
If the door alarm is set to On, an alarm
beeps il any refrigeralor door is left open
for more than three minutes. The beeping
stops when you close the door. The door
alarm Iunction is pre-set to On in the
factory. You carl turn it off by pressing and
then releasing the Alarm button. You can
turn it back on in the same fashion. The
icon lights up when the function is on.
When the Door Alarm function is on and
the alarm sound is triggered, the Door
Alarm Icon will blink while the alarm
sounds.
2) Water Filter Life Indicator Function
After you replace the water filter, touch
and hold this button for 3 seconds to
reset the waler filter life indicator. When
you reset the water filter life indicator,
the Filter icon on the panel turns OFF.The
Filter icon will turn red to let you know it
is time to change the water filter after six
months (about 300 gallons). Some areas
have large amounts of lime in their water,
which causes the water filter to clog more
quickly. If this is the case in your area,
you will have to change the filter more
frequently than every six months.
Touching this button turns Energy Saver
mode on and off. When you turn Energy
Saver on, the Energy Saver icon lights.
rum Energy Saver off and the icon goes
oft. The Energy Saver function's Iactory
setting is "ON". II condensation
or water
drops appear on the doors, turn the
Energy Saver mode off.
Engl sh - 18