Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Frost forms
o n
the walls of the
The water
dispenser
iS not
fu.ctio.i.g,
i
_ i
i
ii
i
The
auto
close
system d oes
not work
with
the
freezer
door.
Condensation
or water
drops
forms
on
Vertical
mUlliOR
aRd
surroundingS,
etc.
i !i
6i!i!
! i i!6!i ! i!i!i!i!i!i!i!ii ii iiiiiii ii i! ii i i i i i i i i iiiiiii
® Is the air vent blocked?
Remove any obstructions
so air can circulate freely.
® Allow sufficient space between the stored foods for efficient air circulation.
® Is the freezer drawer closed properly?
If the freezer drawer is net completely
closed or is blocked, humidity from outside may
enter and cause severe frost to form.
® Is the water line connected
and the shut-off valve opened?
® Has the water supply line tubing been crushed or kinked?
® Make sure the tubing is free and clear of any obstruction.
® Is the water tank frozen because the fridge temperature
is too low?
fry selecting a warmer setting on the Digital display.
® Is the Child Lock on?
® Check if the filter is properly installed.
If it is net properly installed, the water dispenser may not work.
® Is there an imbalance between the right and left parts of the door?
® Open and close the door smoothly 1-_2 times.
After you do this, the auto close system usually works properly again.
® f_y opening the door smoothly to avoid unbalancing the right and the left part of the
door.
®
®
Condensation or water drops may form if the humidity is too high while the refrigerator
is operating.
If cendensation
or water drops appears on vertical mullion and surroundings,
etc., turn
the Energy Saver mode off after removing the condensation.
(See the explanation of the Energy Saver button in "Using the Control Panel" on page
18.)
Engl sh - 35
Publicidad
Tabla de contenido
