Troubleshooting - Tectro TD 10 Instrucciones De Uso

STORAGE
If the machine will not be used for a long period of time, take the following steps:
1 Remove the plug from the socket and empty the container. Allow the container and
the dehumidifier to dry completely.
2 Clean the air filter.
3 Store the device in a dust-free location, preferably covered with a sheet of plastic.
TROUBLE SHOOTING
Check the following before contacting technical support:
Problem
The unit does not work.
The device does not
dehumidify.
The dehumidifier works,
but reduces the relative
humidity insufficiently.
Cause
The powercord is not connected.
The hydrostat setting is too low.
The water container is full.
The water container has not
been replaced correctly.
The air filter is clogged.
The temperature or relative
humidity in the room where the
device is operating is too low.
The room is too large.
There are too many sources of
humidity.
There is too much ventilation.
Solution
Insert the plug into the wall
outlet.
Turn the hydrostat to the
desired setting.
Remove the water from the
container.
Place the water container in the
correct position.
Clean the air filter.
It is normal that the device does
not dehumidify in these
conditions.
We recommend using a
dehumidifier with a greater
capacity.
We recommend using a
dehumidifier with a greater
capacity.
Reduce ventilation (e.g. close
curtains and shut doors).
4
49