Water Drainage - Tectro TD 10 Instrucciones De Uso

WATER DRAINAGE

When the water container is full, the
off automatically. Empty the container and replace it in the correct position. The device
will restart.
If desired, it is possible to connect a drainage hose to the device for permanent water
drainage. Follow these steps:
1 Unscrew the cap on the back.
2 Remove the rubber stop from the drainage spout.
3 Connect the drainage hose and ensure that the end of the hose is lower than the
spout, otherwise the water will not drain and flooding may occur.
4 Place the end of the drainage hose in a water outlet.
When you no longer wish to use the permanent water drainage, disconnect the drainage
hose from the device. Push the rubber stop back into the drainage spout and replace the
cap. Ensure that the water container is positioned correctly.
CLEANING
Switch the dehumidifier off and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth. If the device is extremely dirty, use a mild cleaning
agent. Wipe the device with a slightly damp cloth. Never spray the device with water.
THE AIR FILTER
When used regularly, the filter may become clogged with dust and particles. Therefore the
filter should be cleaned every two weeks. Follow these steps:
1 Remove the water container from the device. Tilt the device backwards a little and
remove the filter.
2 Clean the filter with a vacuum cleaner or with water. Dry the filter and replace it.
Ensure that the filter is completely dry. Replace the water container.
Never use the device without the air filter.
4
48
-light switches on and the dehumidifier switches