Bosch WC18C Instrucciones De Funcionamiento página 10

2610035860_WC18C 8/25/14 8:43 AM Page 10
The wireless charger may be used in
conjunction with the wireless charging holster
WC18H. The holster allows added convenience
by allowing secure installation in the cargo areas
of a vehicle, either fastened to a shelf or to a
wall.
Users with Sortimo® van racking systems may
opt to install the holster between standard
Sortimo® guide rails (Fig. 9a).
Supply in-vehicle power
W RNING
(120V AC) using pure sine
wave inverters only. Failure to use a pure sine
wave inverter may result in a charger
malfunction or decrease in product life.
Do not install wireless
W RNING
charging holster in vehicles
without a permanent barrier between cargo
and passenger areas. Do not install wireless
charging holster in vehicle passenger area.
Wireless charging holster must be installed in
vehicle cargo areas according to mounting
instructions. Failure to properly install wireless
charging holster in a vehicle with a permanent
barrier between passenger and cargo areas
could result in personal injury (Fig. 9b).
Add/Change Holster Inserts
The holster is compatible with the following
Bosch 18V Drill/Drivers and Impact Drivers
through the use of specially-designed inserts
(see Fig. 10a). When purchased as a toolkit, the
correct insert is shipped with the toolkit. When
purchased as a starter kit, the correct insert
should be selected from the Holster Insert
Compatibility table and installed according to the
instructions below.
Note: Refer to Fig. 10a.
Holster-Compatible Tool
DDH181
HDH181
DDH181X
HDH181X
DDS181
HDS181
DDS182
HDS182
25618
IDH182
Using Wireless Charging Holster WC18H
Insert
1
2
3
4
-10-
HOLSTER
WITH TOOL
SORTIMO®
GUIDE R IL
FIG.9b
P SSENGER PERM NENT
RE B RRIER
1. Remove Screw/Nut 1.
2. Loosen the (2x) Screw 2.
3. Remove installed inserts, pinching the bottom
of inserts and pulling them from the holster.
4. Position new inserts, matching left and right
sides appropriately. Grooves in inserts and
holster should align.
5. Retighten (2x) Screw 2.
6. Reattach and tighten Screw/Nut 1.
Installing the Charger into the Holster
1. Slide the charger into the tray. (Fig. 10b) Be
sure that the charger is fully inserted into the
tray and that the cord is routed out the back
of the tray.
2. Slide the tray into the holster.
WCBAT612-WCBAT615 batteries, slide the
tray guide rails into the upper tray guide slot.
For WCBAT620-WCBAT625 batteries, slide
the tray guide rails into the lower tray guide
slot. Be sure to route the power cord through
the back of the holster. (Fig 10a)
Removing the Charger from the Holster
1. Unplug the power cord from power supply
2. Remove the tray from the holster (Fig 10a)
3. Remove the charger from the tray by first
pulling charger up, then out of the tray (Fig.
10b).
FIG.9a
C RGO
RE
For