Descargar Imprimir esta página

Bosch WC18C Instrucciones De Funcionamiento página 4

Ocultar thumbs Ver también para WC18C:

Publicidad

Idiomas disponibles

Idiomas disponibles

2610035860_WC18C 8/25/14 8:42 AM Page 4
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) this device may not cause interference,
and
When batteries are not in
W RNING
tool or charger, keep them
away from metal objects. For example, to
protect terminals from shorting Do NoT place
Do not attempt to disas-
W RNING
semble the battery or
remove any component projecting from the
battery terminals. Fire or injury may result.
Prior to disposal, protect exposed terminals
with heavy insulating tape to prevent shorting.
Lithium-ion Batteries
If equipped with a lithium-ion battery, the
battery must be collected, recycled or disposed
of in an environ mentally sound manner.
"The EPA certified RBRC Battery
Recycling Seal on the lithium-ion
(Li-ion) battery indicates Robert
Bosch Tool Corporation is
voluntarily participating in an
AN
W RNING
SHoULD NoT Be USeD
UNLeSS ABSoLUTeLy NeCeSSARy. Use
of improper extension cord could result in risk
of fire and electrical shock. If an extension cord
is used, make sure:
a. The pins on plug of extension cord are the
same number, size, and shape as those of plug
on charger.
b. The extension cord is properly wired and in
good electrical condition.
c. The wire size is large enough for AC ampere
rating of charger as specified below:
Industry Canada
Battery Care
Battery Disposal
extension Cords
exTeNSIoN
CoRD
(2) this device must accept any interference,
including interference that may cause
undesired operation of the device.
batteries in a tool box or pocket with nails,
screws, keys, etc. Fire or injury may result.
Do NoT PUT BATTeRIeS INTo FIRe oR
exPoSe To HIgH HeAT. They may explode.
industry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a
convenient alterative to placing used Li-ion
batteries into the trash or the munici pal waste
stream, which may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation's involvement in this program is
part of our commitment to preserving our
environment and conserving our natural
resources."
d. An extension cord is a temporary solution.
Move the charger to a standard receptacle as
soon as the job has been completed.
Length of
25
Cord, Feet
WG Size
18
of Cord
Extension Cord Chart for 220/240 Volt Tools:
0.75mm
2
CORD
1.0mm
2
CORD
-4-
50
100
150
16
16
14
50 Meters
75 Meters

Publicidad

loading

Este manual también es adecuado para:

Wc18fWc18h