Pioneer PDP-S13-LR Manual De Instrucciones página 3

INSTALLATION ON THE PLASMA
DISPLAY
(WHEN INSTALLING THE SPEAKERS ON THE RIGHT AND
LEFT SIDES OF THE DISPLAY)
Perform installation according to the following steps 1 to 2.
1 Attach the mounting fittings to the
speakers.
The illustration below shows the right speaker.
1 Align the convex portion of the holder for installing the
speakers on the right and left sides with the concave
portion of the speakers.
2 Fix the two points with screws.
3 Attach holders to the top and bottom of one speaker.
1
4 Similarly, attach two holders to
the top and bottom of the other
speaker.
2 Attach the speakers to the display.
The illustration below shows how to attach of the right speaker.
1 Fix the upper screw temporarily in
advance to hang the speaker on
the display (In this case, leave a
space of about 5 mm between the
head of the screw and the display).
2 Hang the speaker on the upper
screw.
3 Fix the lower screw temporarily.
4 Adjust the position so that the speaker is parallel to the
display and then fix the upper and lower screws firmly.
2
2 3
The display
5mm
4
3
5 Attach the left speaker following the
same procedure as described above.
INSTALLATION ON THE PLASMA
DISPLAY
(WHEN INSTALLING THE SPEAKERS AT THE BOTTOM
OF THE DISPLAY)
Perform installation according to the following steps 1 to 2.
1 Attach the mounting fittings to the
display.
1 Push rivets into each outside hole A of brackets (on the
right and left sides) for installing the speakers at the bottom.
2 Fix each outside hole B of brackets (on the right and left sides),
for installing the speakers at the bottom, with screws.
B
2
1
A
3 Insert the screws into the two outside holes of bracket
(at the center), for installing the speakers at the bottom,
and tighten them.
4 Align the bosses of the spacer with the holes of the stand
and insert them.
English
2
B
A
1
3