Quick Start - Elnur Gabarron ECOMBI PLUS Serie Instrucciones De Uso

2.2. Quick Start

Ecombi Plus quick start only requires 2 easy settings:
TIME AND CHARGE SETTING
Charging Hours: By default, Ecombi Plus off-peak period is set from 00:00 to 08:00. In case off-peak period of your electricity
tariff does not match with this setting, you can easily modify it:
- With backlight on, keep pressed
general configuration menu.
- Press button until the text "PArA" is displayed blinking.
- Press now button to access general parameteres menu (PArA).
- Parameter UP01 is displayed. Charging period used by Ecombi Plus goes from UP02 parameter (Charging period start.
By default 00:00) to UP03 parameter (Charging period end. By default 08:00).
- Use and
button to access the parameter value.
- Use and
desired value.
- Press to exit main menu.
Time setting: Ecombi Plus time setting is set on factory by default. Check the time setting in your device. In case time setting is
wrong, you can easily modify it following next steps.
OPERATION MODE SETTING & TEMPERATURE SET POINT
1. With backlight on, keep pressed
general configuration menu.
2. Press button when the message "Func." is displayed to access operation mode menu.
3. Press or buttons to select basic (24 hours Set-Point Temperature) operation mode. Press
Current charge level and set-point temperature are displayed in this mode.
4. Once selected, adjust the desired set-point temperature using
daily its charging level to provide the selected temperature with minimal cost.
button for 5 seconds until the message "Func." is displayed blinking to access the
buttons to move forward and backward until the parameter to be modified is displayed. Press
buttons to modify the time of the start / end of the charging period. Use
button for 5 seconds until the message "Func." is displayed blinking to access the
and . Automatically, Ecombi Plus will manage and adjust
20
button to confirm the
button to confirm.