Assembly; Assembling The Machine Stand - imaport Siena SN270BT Manual De Instrucciones

ASSEMBLY

This metal cutting bandsaw is completely assembled, just needs
to assemble the machine stand.
Assembling the machine stand as shown in Fig.1.
Fig 1
Carefully lift the saw head onto base, and fasten the machine
head by 4xHex head screw M10x25, spring washer M10 and
washer 10mm.
Before starting to lift the machine make sure that all movable
parts have been securely fastened.
Ensure that the crane s lifting capacity is suitable for the
machine. Lift the machine carefully and move it slowly, avoiding
bumps or sudden movements.
The lifting and transporting operations can be extremely
dangerous if not carried out with maximum caution.
Move all unqualified personnel away from the area. Clean,
clear and close off the installation area.
Check the condition and suitability of the equipment
available.
Do not touch the suspended loads and remain at a safe
distance from them.
Fig 2
Assemble the loose parts and accessories
Fit the components supplied:
Mount bar stop rod.
Dis activation of machine
If the machine is to be out of use for a long period, it is
advisable to proceed as follows:
Detach the plug from the electric supply panel,
Loosen blade,
Release the arch return spring,
Lowing the saw arm as possible,
Empty the coolant tank,
Carefully clean and grease the machine,
If necessary, cover the machine.