Troubleshooting - brondell P300 Serie Manual Del Propietário

7 TROUBLESHOOTING

CONDITION
Unit cannot be
switched on.
Fan not working.
Fan speed does
not automatically
adjust when the
Auto Mode is
activated.
Machine is beep-
ing.
13
POSSIBLE CAUSE
Front Panel is not placed properly.
Power plug is not properly
inserted into the electrical outlet.
Power plug or cord is damaged.
Unit is in Lock Mode and stops
operation because exhausted
filters are not replaced.
Safety fuse is blown.
Unit is not switched on.
Motor requires servicing.
Plastic wrap on filters not removed. Remove the plastic bags and put
Air Quality Sensor is faulty and
alarm will be heard. Air Quality
Indicator will flicker in green.
Night Mode is activated when
the ambient light is dimmed for
3 minutes.
Filters need to be changed and the
filter change indicator reset.
POSSIBLE SOLUTION
Remove the Front Panel and
reattach it onto the unit again.
Unplug the unit and plug it back
into the electrical outlet.
Contact the Brondell Service Center.
Clean the Mesh Pre-Filter, replace
HEPA and carbon filters with a new
set, and reset filter change indicator.
Refer to Filter Replacement on page
10 of this manual.
Replace safety fuse. See Section
6.4 on page 12 for instructions.
Ensure the unit is properly plugged
into the outlet.
Contact the Brondell Service Center.
filters back in.
Contact the Brondell Service Center.
Press Auto Mode or Fan Speed
Button.
Unit will resume its normal
operation when light sensor detects
ambient light for 5 minutes.
Refer to filter replacement
instructions on page 10