Troubleshooting - brondell REVIVE PR50-W El Manual Del Propietario

TROUBLESHOOTING

CONDITION POSSIBLE CAUSE
Plastic packaging on filters was not
No air is blowing.
removed.
The power cord is not plugged in or
properly inserted into the electrical
outlet.
Power plug or cord is damaged.
The Revive is not powered on.
CONDITION POSSIBLE CAUSE
Manual Mode is selected.
1. Fan speed does
not automatically
adjust when in
Air Quality Sensor is dirty.
Auto Mode.
2. The color of the
Air Quality Indicator
never changes.
Air Quality Sensor sensitivity is
inadequate for the air quality in
the room.
Air Quality Sensor is broken or is
malfunctioning.
CONDITION POSSIBLE CAUSE
Only the
Air Purification
(AIR) and The Light Off Button has been
Humidifying (HUM) pressed.
indicators are
illuminated.
1
1, 2
1, 2
1, 2
POSSIBLE SOLUTION
Remove the plastic packaging and
put the filters back in.
Plug the power cord into an electric
outlet rated for 120V.
Contact the Brondell Service Center
at 888-542-3355.
Press the Power Button.
POSSIBLE SOLUTION
Press the Mode Button until "Auto"
is illuminated.
Follow the steps on page 28 to
clean the Air Quality Sensor.
Follow the steps on page 19 to set a
different Seasonal Allergy Setting:
• If the Air Quality indicator is Blue,
use a higher sensitivity.
• If the Air Quality Indicator is
Purple or Red, use a lower
sensitivity.
Contact the Brondell Service Center
at 888-542-3355.
POSSIBLE SOLUTION
Press the Light Off Button again
to restore the control panel to full
illumination.
29