Waeco CoolMatic CD50 Instrucciones De Montaje página 38

Installing and connecting the refrigerator
A
NOTICE!
Disconnect the refrigerator and other electric loads from the bat-
tery before connecting the battery to a quick charging device.
Overvoltage can damage the appliance electronics.
For safety reasons the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against
reversed polarity when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage
is insufficient (see table below).
Cut-off voltage
Cut-in voltage
Connecting the refrigerator to AC power (accessory)
D
DANGER! Danger of fatal injury!
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your refrigerator on board a boat with a
mains connection of 230 V using a shore connection, you must
install a residual current circuit breaker between the 230 V
mains supply and the refrigerator.
Seek advice from a trained technician.
You can connect the refrigerator to 110 – 240 V AC power if you use the
MPS35 rectifier (accessory).
The MPS35 features a priority circuit which conserves the battery connected.
When a 110 – 240 Vw mains connection is used, the rectifier automatically
switches from battery to mains operation.
When disconnected from the 110 – 240 Vw mains supply, the rectifier auto-
matically switches back to battery operation. Mains operation using the rec-
tifier always takes priority over battery operation.
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Affix the rectifier in its intended position behind the refrigerator (fig. 9,
page 6), as shown.
➤ Protect the AC circuit using a slow-blow fuse (250 V/4 A) (fig. 9 3, page 6).
38
CD50, CRD50
12 V
10.4 V
11.7 V
24 V
22.8 V
24.2 V
EN