Changing Air Direction; Normal Sounds - Whirlpool CA10WXP0 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fan Speed
Set FAN SPEED to the desired setting. When the air conditioner
is operating at Low Cool, High Cool, or Turbo Cool, the fan
circulates air continuously.
Turbo Cool - for maximum cooling
High Cool - for normal cooling
Low Cool - for sleeping comfort
Fan Only - to move air continuously without cooling
NOTE: Fan runs on Turbo speed only.
Power Saver (on some models) - fan runs only when
cooling is needed. Fan stops circulating air when the
room temperature matches the Temperature control
setting.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
Model 1
Model 2
Temperature
Turn the TEMPERATURE control to a mid-setting. Adjust the air
conditioner's performance by turning the Temperature control
clockwise for maximum cooling. For less cooling, turn the
TEMPERATURE control counterclockwise. Experiment to find the
setting that suits you best.

Changing Air Direction

Roll the wheel to direct the air right or left. Rotate the whole
cartridge to direct air up, down or straight ahead.
1
1. Cartridge

Normal Sounds

When your air conditioner is operating normally, you may hear
sounds such as:
Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
Air movement from the fan.
Clicks from the thermostat cycle.
Vibrations or noise due to poor wall or window construction.
A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
1. Wheel
1
11

Publicidad

Tabla de contenido
loading

Tabla de contenido