Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Driving and removing of small screws, small bolts, etc.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Rechargeable
battery
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Battery
Pilot Lamp
Fig. 4
12
Insert
Pull out
Latch
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you.
(Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch of the battery. (Fig. 3)
1. Insert the battery into the battery charger.
Insert the battery into the battery charger as
shown in Fig. 4. Make sure it contacts the
bottom of the battery charger.
2. Insert the plug of battery charger into the
receptacle.
WARNING:
Do not use the electrical cord
if damaged. Have it repaired
immediately.
Publicidad
Tabla de contenido
