Before Use; Operation - Hitachi WH 12DAF Manual De Instrucciones

English

BEFORE USE

Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.

OPERATION

1. Using the light equipped hook
CAUTION:
Do not attach the tip tool to the tool main unit when carrying the tool main unit with
the light equipped hook suspended from a waist belt.
Such action could result in injury.
The light equipped hook has the following two functions:
It can be used as a hook for suspending from a waist belt when required by the
nature of the work.
It can be used as an auxiliary light for such operations as tightening screws in a
dark place.
1.1 Using the hook
The hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between
0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction
of arrow (A) and turn in the direction of arrow
(B). (Fig. 5)
(b) The angle can be adjusted in 5 steps (0°, 20°,
40°, 60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
G
If the tool falls, there is a risk that malfunction
and/or physical damage can occur.
recommended that you also use fall-preventing
wires, etc.
G
Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin. (Fig. 6)
(b) Remove the hook and spring. (Fig. 7)
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 6)
14
2
1
Loosen
It is
Hook
5
4
Hook
3
(B)
(A)
Fig. 5
Fig. 6
Spring
Fig. 7